4" Spacer Block

This solid piece of 4” square 8” long bar stock is placed on the treadle hammer bolster with locating pins located in rear to keep it in place during use.
Used on Treadle  Hammer when tooling is not in use beneath material being worked. The tool holding tubes front &  rear hold any number of specialty tools you make. Available in 5" & 6" heights.

304  4" Spacer Block (38 lb.) $81.00

(Not Shown)
305  5" Spacer Block (16lb.) $73.50

308  6" Spacer Block (17 lb.) $74.50

 Hardy Adapter

Designed for use on the Treadle Hammer to hold hardy tools at 45 degree angle to the hammer. This allows you to work comfortable at hammer while using hard tools.

(See Figure 8 in Delivering the Perfect Strike-Revisted which illustrates a fullering tool used in conjunction with adapter.

306  HardyAdapter (4lb.) $49.50

Chisel Plate

This plate is used in conjunction with 4" Spacer Block When using a chisel for splitting material.
The 1/4" x 4" x 8" plate is a consumable, requiring replacement when it is used to capacity. Adpater for the plate may also be used for holding tools of your design.

306  (4lb.) ea                   $37.50

Vise Grip

For obvious reasons, you never want to hold a tool with your hand while using a treadle hammer. This vise grip provides the needed extention. Buy them now and save yourself the trouble of making them or any lost production time due to injury.

VG (2 lbs.) ea. $25.00